Check substrates, product information, samples and adjoining work before installing fit-out finishes. Record area-by-area release decisions.

Overview

A finish is only ready to install when the surface beneath it meets the requirements of the selected system. Ask the contractor to identify what must be checked, who will check it and how any remedial work will affect sequencing. Keep the surface decision separate from approval of the visible colour or texture.

Identify what is underneath

Record whether the finish goes over a new or retained surface and note where previous coatings or repairs are visible. Ask what site information is still missing, especially in areas affected by earlier leaks or alterations. Have the responsible team investigate the cause of any suspected moisture or movement before work covers the evidence.

For the related planning decisions, read the guide to choosing a lasting material palette.

Agree acceptance criteria with the installer

Use the selected manufacturer’s written requirements and the responsible professional’s advice for the actual assembly. Ask which checks are needed for preparation, compatibility or site conditions and who will document them. A repaired patch may look acceptable while still needing a different preparation process from the surrounding area. Record the decision with the relevant product references.

Review a sample area under site conditions

Where appropriate, ask the installer to show a representative sample that includes an edge, joint or transition. Review it against the finish selection and the intended use. A small sample board can show colour, but a site sample can reveal how a detail meets adjacent surfaces. Agree which observations require an adjustment before installation proceeds.

Work through an example

Suppose a retained floor has visible repairs near a former partition. Ask the installer which areas need to be assessed and whether the selected finish can be installed over the current build-up. Record who will confirm preparation and use a representative sample at the transition so the finish decision includes the actual conditions.

Release the surface in stages

Mark which areas are ready and which need additional work or assessment. Keep a dated record of checks, remedial work and acceptance. Let the programme reflect any hold points rather than expecting the installer to resolve every unknown after materials have arrived.

Bring your current plan and the decisions still open when you discuss civil construction and renovation.

Agree a hold point for the surface

Ask the installer which conditions and checks are needed for the chosen finish and substrate. Record who confirms them and what evidence the project needs. A surface that looks clean may still have unresolved preparation, moisture or compatibility questions requiring specialist review.

Compare the approved sample area with the intended lighting and junction details. Record the finish reference and installation revision before extending the work. If the substrate or product changes, revisit the relevant checks rather than carrying the earlier approval across automatically.

Can every finish be installed using the same surface-preparation method?

No. Requirements vary by product, substrate and site condition. Use the selected manufacturer's current instructions and the responsible installer's assessment rather than a generic rule from an unrelated material.

Discuss your project

Share the finish schedule, sample decisions and remaining preparation questions to discuss your fit-out scope. Explore civil construction and renovation to discuss the relevant scope.

Related guides and services

Have a project in mind?Let’s start a conversation